The Titan Controls Atlas 1 CO2 Controller with Remote Sensor is one of the best ways to provide the perfect amount of carbon dioxide to your indoor plants. IT comes with a 25-foot remote sensor and can be adjustable to multiple set points and elevation levels. With more features like a built-in self-calibration function, integrated photocell, and much more, this is one of the best monitor and controller combos on the market.
Increase Yields With The Titan Controls Atlas 1 CO2 Controller with Remote Sensor
When you grow outdoors, your plants have access to all the fresh air they could ever need. But when you grow indoors, you will struggle to keep CO2 PPM's where they need to be for ideal plant growth. If you have powerful enough grow lights, your plants will experience a huge explosion in growth rates and harvest weight when you supplement with CO2.
But, you need a means of controlling the flow rate of your CO2 - and this Titan Controls Atlas 1 CO2 Controller with Remote Sensor is one of the best ways. It's super simple to use and setup and comes with a ton of features to make your life easier. The integrated photocell function will only activate CO2 devices during lights on, which is when your plants can actually use CO2.
It only sucks 15 amps on the 120-volt outlet and operates at 60 Hz. If needed, you can purchase a replacement probe separately. The included sensor comes factory calibrated for precise and accurate CO2 readings and is engineered to prevent RFI from electronic ballasts.
To program the Titan Controls Atlas 1 CO2 Controller with Remote Sensor, you'll use the increase and decrease buttons located on the front to set your PPM output. There is a green LED indicator between the two buttons that will illuminate when the CO2 device is "active". We recommend setting the PPM's between 1,000-1,500 PPM's for explosive plant growth and remaining safe.
How The Titan Controls Atlas 1 CO2 Controller Works:
Titan Controls Atlas 1 CO2 Controller
- Sampling Method = Infrared Diffusion
- Measurement Range = 300 PPM to 5100 PPM
- Control Range = 0 PPM to 2050 PPM
- Accuracy: +/- 5% (total reading)
- Response Time: Approximately 45 seconds
- Fixed Hysteresis/Deadband = 50 PPM (centered)
- Signal Update: Displayed CO2 PPM reading updates once every 3 seconds
- Warm-up Time: Approximately 30 minutes
- Recommended Calibration Interval = Every 3 years
- Stability: Typical Deviation ±75 PPM a year
- Operating Temperature = 32° F (0°C) to 120° F (50°C)
- Input Voltage = 120VAC, 60 Hz.
- Output Voltage = 120VAC, 60 Hz.
- Maximum Operating Amperage: 15 Amps
- RoHS Compliant = Yes
Learn more about grow room CO2 in our blog.
Not sure how much CO2 you need to add to your grow room? Check out our CO2 calculator .
Caution: Sulphur vaporization can damage your controller! To protect your controller, it is important to disconnect and cover the Atlas 2 by wrapping with a plastic bag OR remove the controller from the grow area while using sulphur vaporizers in your grow room.